SES HART Device Stack

Overview

SES HART device stacks enables traditional 4-20 ma sensor implementation to be readily redesigned as HART enabled 4-20 ma devices. It does not require great expertise from designers about HART protocol. The code can be very easily configured to be different device type such as Temperature, pressure, position sensors and even actuator. SES stack has been used in multiple registered devices with Fieldcomm Group.

Features of the SES HART Device Stack are:

• Implemented on small, embedded microcontrollers such as MSP430 or STM32 with smaller code and data memory requirements.
• Portable for other devices.
• Implements all HART universal commands and many common practice commands.
• Burst Mode, Event Notification features are supported.
• SES custom firmware engineering allows for quick migration to your architecture
• All Data Link Layer timings are properly addressed.
• RTOS or Bare Metal implementation is possible.

Contact

Baldev Krishan, Ph.D.
Email: [email protected]
Phone: 510-304-6830
Web: www.smartembeddedsystems.com